Beside Turn display off when inactive select Never.

But what if you want to start the Mac up without opening the lid to reveal the power button. It’s easy to wake your MacBook from sleep without opening the lid – just click or move the mouse or tap on the keyboard. How to turn on the MacBook with the lid closed Using a second display with your Mac here.

You may find that your MacBook needs to be plugged in via the power adaptor for the screen to appear on the external monitor, but ours didn’t.

Your external monitor may flash off for a moment but it will then show your Desktop (you may need to wake your Mac by pressing a key on the keyboard or moving the mouse).

After your Mac notebook’s Desktop appears on the external display, close the computer’s lid.

If you are using a Bluetooth mouse and keyboard, make sure that Bluetooth is on and that the peripherals are paired with the Mac.

Connect an external mouse (can be wireless).

Connect an external keyboard (can be wireless).

In fact if you are experiencing issues using your Mac with the lid closed then it is likely that you could address this by updating your Mac to a recent version of macOS – assuming your Mac supports it, otherwise, try these steps below. P.S.: If you do not wish to remove the case yourself, it is advisable you seek professional assistance.The good news is that this is a lot simpler than it used to be if you are using a newer Mac and a newer version of the Mac operating system. You can close the lid to place the MacBook Air in sleep mode (while plugged in), and carefully plug in the battery connector while it's powered on.

Once the battery connector is removed, put the MacBook Air in upright position, plug in the charger and turn on the power.

Grab the clear plastic pull tab attached to the battery connector and pull it toward the front edge of the Air to disconnect the battery from the logic board.Now remove the battery connector as instructed in the article, MacBook Air 13' Early 2015 Battery Replacement. Wedge your fingers between the display and the lower case and pull upward to pop the lower case off the Air.You'll need a special screwdriver that can remove 5-point Pentalobe screws. Remove the 10 screws using the below mentioned screwdrivers.:ĩ mm P5 Pentalobe screws (2 nos.) (Shown in Red).Ģ.6 mm P5 Pentalobe screws (8 nos.) (Shown in Orange). You can follow the instructions shared on the iFixit website, MacBook Air 13' Early 2015 Lower Case Replacement, to remove the bottom case: You'll need to open the bottom case of your MacBook Air and remove the battery connector.

How to turn on macbook pro ir